 |
|
Label
Pro | Captain B
| Meltcator
Hot Melt Roll Coater |
Label
Pro
Label Gluer
The
Label Pro® 5.5 can glue labels up to 5.5" wide (14
cm) quickly and neatly. It is the world’s most compact
label gluer! A corduroy pattern of adhesive is applied across
the entire label, reducing adhesive consumption by up to 50%!
It is
available with or without a motor (120 & 220 volts).
When a label is fed into the motorized gluer, the motor
turns on pulling the label through the gluer. The motor
stops one second after the label exits, reducing wear and
tear and increasing the pot life of the adhesive.
|
 |
Captain
B
Label Gluer
The Captain B is a rugged label gluer available with
8", 10", and 14" (20, 25, 40 cm) roller widths.
It’s removable glue tray means easy access and cleanup.
For information about the new motor for the Captain B, click
here.
The
gear motor is fully enclosed with direct drive for safe
operation. The built-in speed control (standard on the 120
volt gluer, optional on the 220 volt gluer,) increases its
ease of use.
Options
include:
•
An explosion proof air motor for use in hazardous environments.
•
Strip gluing to reduce adhesive consumption.
•
A pressure bar attachment for gluing rigid or thick board
stock or envelopes.
|
|
Meltcator
Hot Melt Roll Coater
This new, 120 volt system (220 volts available) is ideal for
applying hot melt adhesives onto flat surfaces. Great for
corrugated build-up, gluing foam to foam and foam to corrugated
for protective packaging. The unit above shows the optional
Pressure Bar Attachment for materials up to 1/2" (1.3
cm) thick. Without the attachment the operator moves the item
to be glued over the glue roller. It's glue tank holds about
five pounds of hot melt.
An electronically
controlled thermostat provides variable temperature control.
The speed of the roller is also variable. There is a motor
lock-out switch to prevent damage to the motor if it is
turned on before the adhesive is molten. This heavy duty
roll coater is designed for years of service in a factory
setting.
For
gluing thick materials the MELTCATOR is available without
the pressure bar attachment shown above.
The photo below shows adhesive being applied onto a foam
block.
|
 |
|
|
|
